PENGARUH WAKTU REAKSI DAN RASIO MOL ASAM LINOLEAT DENGAN ISOPROPANOL PADA SINTESA PLASTISIZER ISOPROPIL LINOLEAT

Authors

  • Nirwana - Jurusan Teknik Kimia Fakultas Teknik Universitas Riau
  • Irdoni HS - Jurusan Teknik Kimia Fakultas Teknik Universitas Riau
  • Joni Miharyono Jurusan Teknik Kimia Fakultas Teknik Universitas Riau

DOI:

https://doi.org/10.25077/jrk.v9i1.255

Keywords:

Asam Linoleat, Esterifikasi, H-Zeolit, Isopropanol, Plastisizer

Abstract

Diversity of palm oil product in Indonesia is still limited, therefore it is needed to take an advantage of the development of downstream product of crude palm oil by esterification reaction. Esterification reaction is a reaction between carboxylic acid and alcohol to form ester. One of the emerging downstream product fatty acid alkyl ester is plasticizer. Plasticizer is an additive compound added to polymer to improve flexibility and workability. The purpose of this research was conducted to study the effect of reaction time and mole ratio and identify product of plasticizers isopropyl linoleic. In this research, plasticizer was synthesized by esterification of linoleic acid and isopropanol, using activated natural zeolite catalyst. The process was done with a variation of reaction time (4, 6, and 8 hours) and mole ratio (1: 6, 1: 9, and 1:12), with reaction temperature at  80 °C,  stirring speed at 200 rpm and 15% of composition of linoleic acid based catalyst as fixed variables. From the analysis of the results showed that the esterification reaction time and mole ratio affect the product conversion. The best operating condition obtained  in this research was 4 hours of reaction time and 1:12 of mole ratio which resulted the conversion of reaction was 67.09%. Characteristics of plasticizer produced from this research were viscosity (at 20 °C) 2.405 to 2.803 mPa.s and Specific Gravity (at 20 °C) from 0.863 to 0.872.

References

Rosalina. 2012. Perusahaan Sawit Terus Ekspansi Lahan. http://www.tempo.co/ read/news/2012/03/13/090390054/Perusahaan-Sawit-Terus-Ekspansi-Lahan, 29/12/ 2013. Pkl 20.00 WIB.

Departemen Perindustrian Indonesia, Gambaran Sekilas Industri Minyak Kelapa Sawit. Jakarta (2010).

Handayani, A.S., Marsudi, S., Nasikin, M., Sudibandriyo, M., Reaksi esterifikasi asam oleat dan gliserol menggunakan katalis asam. Jurnal Sains Materi Indonesia. Edisi Oktober, 102-105 (2006).

Haryono, A, Pengembangan Plastisizer Pengganti DOP dari Turunan Minyak Sawit. Bandung: Pusat Informasi dan Dokumentasi IPTEK LIPI, (2006).

Vieira, M.G.A, Mariana A.D.S, Licielen O.D.S ,. Natural based plasticizer and biopolymer films: A review, Eur. Polym. J. 47: 254-263 (2011).

Leach, B.E. Applied Industrial Catalysis. Volume 2. New York: Academic Press. Inc. (1983).

Hidesi, H., Heteregoneous basic catalysis. Chem. Rev. (95)3: 537-558 (1995).

Nasikin, M., Perengkahan katalitik fasa cair minyak sawit menjadi biogasolin. Prosiding Seminar Nasional Teknik Kimia Indonesia. Palembang 19-20 Juli. KKR 08-1, (2006).

Trisunaryanti, W., Triwahyuni, E., Preparasi modifikasi dan karakteristik katalis ni-mo/zeolit dan mo-ni/zeolit alam. TEKNOIN, (10)4: 269-282, (2005).

Susanto, B, Nasikin M, Sukirno. Sintesis pelumas dasar bio melalui esterifikasi asam oleat menggunakan katalis asam heteropoli/zeolit. Prosiding Seminar Nasional Rekayasa Kimia dan Proses. Semarang: Universitas Diponegoro, (2008).

Gunawan. Pengaruh waktu reaksi dan perbandingan molar pada proses pembuatan isobutil oleat dengan katalis zeolit alam. Skripsi. Pekanbaru: Universitas Riau (2012).

Wypych, G, Handbook of Plasticizer, Chemtech Publishing, Inc. (2004).

Downloads

Published

2015-04-07

How to Cite

-, N., -, I. H., & Miharyono, J. (2015). PENGARUH WAKTU REAKSI DAN RASIO MOL ASAM LINOLEAT DENGAN ISOPROPANOL PADA SINTESA PLASTISIZER ISOPROPIL LINOLEAT. Jurnal Riset Kimia, 9(1), 19. https://doi.org/10.25077/jrk.v9i1.255

Issue

Vol. 9 No. 1 (2015): September

Section

Articles

Citation Check

License

Please find the rights and licenses in Jurnal Riset Kimia (J. Ris. Kim). By submitting the article/manuscript of the article, the author(s) agree with this policy. No specific document sign-off is required.

1. License

The use the article will be governed by the Creative Commons Attribution license as currently displayed on Creative Commons Attribution 4.0 International License. 

2. Author(s)' Warranties

The author warrants that the article is original, written by stated author(s), has not been published before, contains no unlawful statements, does not infringe the rights of others, is subject to copyright that is vested exclusively in the author and free of any third party rights, and that any necessary written permissions to quote from other sources have been obtained by the author(s).

3. User Rights

Under the Creative Commons license, the journal permits users to copy, distribute, and display the material for any purpose. Users will also need to attribute authors and J. Ris. Kim on distributing works in the journal and other media of publications.

4. Rights of Authors

Authors retain all their rights to the published works, such as (but not limited to) the following rights;

  • Copyright and other proprietary rights relating to the article, such as patent rights,
  • The right to use the substance of the article in own future works, including lectures and books,
  • The right to reproduce the article for own purposes,
  • The right to self-archive the article,
  • The right to enter into separate, additional contractual arrangements for the non-exclusive distribution of the article's published version (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.

5. Co-Authorship

If the article was jointly prepared by more than one author, any authors submitting the manuscript warrants that he/she has been authorized by all co-authors to be agreed on this copyright and license notice (agreement) on their behalf, and agrees to inform his/her co-authors of the terms of this policy. J. Ris. Kim will not be held liable for anything that may arise due to the author(s) internal dispute. J. Ris. Kim will only communicate with the corresponding author.