Pengaruh Penggunaan Fly Ash dari Berbagai Sumber terhadap Sifat Kimia dan Sifat Fisika pada Semen Tipe I (OPC)

Yulizar Yusuf, Vivin Firman Savitri, Hermansyah Aziz

Abstract

The aim of this study is to utilize fly ash from various sources on chemical and physical properties of cement type I (OPC). Utilization of fly ash can improve the strengthness of the cement. It can reduce the waste of fly ash by utilization into cement process. The procedure has been carried out on cement type I (OPC) with the addition of fly ash additives from various sources with concentration variations such as 10% and 20%. Utilization of fly ash as additives substance in cement works to improve the quality of cement. The main parameter in determining the quality of cement is determined by the compressive strength. The results of the compressive strength test showed that the addition of fly ash with a concentration of 10% had a higher effect on the compressive strength than the addition of a concentration of 20%. 5 types fly ash from various sources, fly ash from PT Sinar Mas gives greater compressive strength at 28 days. the addition of fly ash additives to OPC cement mixture has chemical and physical properties which are not much different from properties of PCC cement.

Keywords

Fly ash; OPC cement; Compressive strength

Full Text:

PDF

References

Purnawan, I. & Prabowo, A., Pengaruh penambahan limestone terhadap kuat tekan semen portland komposit. J. Rekayasa Proses, 11(2): 86 (2018).

Firnanda, A., Kurniawandy, A. & Ermiyati, E., Kuat tekan beton dan waktu ikat semen portland komposit (PCC). J. Online Mhs. Fak. Tek. Univ. Riau, 1(1): 1–11 (2014).

Hariawan, J. B., Pengaruh perbedaan karakteristik type semen ordinary portland cement (OPC) dan portland composite cement (PCC) terhadap kuat tekan mortar. Universitas Gunadarma, (2007).

YAZICI, Ş. & AREL, H. Ş., Effects of fly ash fineness on the mechanical properties of concrete. Sadhana, 37(3): 389–403 (2012).

Philip, A., Marthin, M., Sumajouw, D. J. & Windah, R. S., Pengaruh penambahan abu terbang (fly ash) terhadap Kuat tarik belah beton. J. Sipil Statik, 3(11): 729–736 (2015).

Pratama, S. W. I., Rauf, N. & Juarlin, E., Pembuatan dan pengujian kualitas semen portland yang diperkaya silikat abu ampas tebu. Universitas Hasanuddin, (2015).

Priambodo, I. S., Pengaruh penambahan fly ash terhadap kualitas fisika dan kimia pada produksi portland composite cement (PCC). Universitas Muhammadiyah Purwokerto, (2016).

Kesharwani, K. C., Biswas, A. K., Chaurasiya, A. & Rabbani, A., Experimental study on use of fly ash in concrete. Int. Res. J. Eng. Technol., 4(9): 1527–1530 (2017).

Rommel, E., Kurniawati, D. & Pradibta, A. P., Perbaikan sifat fisik dan reaktifitas fly ash sebagai cementitious pada beton. Media Tek. Sipil, 12(2): (2015).

Madurwar, K., Burile, A. & Sorte, A., Compressive strength of cement & fly ash mortar: a case study. in Proceedings of Sustainable Infrastructure Development & Management (SIDM), (1): (2019).

Harison, A., Srivastava, V. & Herbert, A., Effect of fly ash on compressive strength of Portland pozzolona cement concrete. J. Acad. Ind. Res., 2(8): 476–479 (2014).

Ulum, M. B., Karakteristik fisik dan kimia fly ash dari perusahaan ready mix beton dan limbah pabrik terhadap sifat mekanik pasta dan mortar. Institut Teknologi Sepuluh Nopember, (2015).

Weluk, A. F. B., Verifikasi metode penentuan hilang pijar, bagian tak larut (BTL), Fe2O3, dan SO3 dalam semen OPC di Plant IX PT. Indocement Tunggal Prakarsa Tbk. Palimanan-Cirebon. Universitas Islam Indonesia, (2018).

Li, Y., Lin, H. & Wang, Z., Quantitative analysis of fly ash in hardened cement paste. Constr. Build. Mater., 153: 139–145 (2017).

Farida, R., Optimasi karakteristik kualitas portland pozzoland cement menggunakan metode Taguchi dengan pendekatan fungsi desirability regresi fuzzy Di PT. Semen Indonesia (Persero), Tbk. Institut Teknologi Sepuluh Nopember, (2017).

Kaewmanee, K., Krammart, P., Sumranwanich, T., Choktaweekarn, P. & Tangtermsirikul, S., Effect of free lime content on properties of cement–fly ash mixtures. Constr. Build. Mater., 38: 829–836 (2013).

Article Metrics

Metrics Loading ...

Metrics powered by PLOS ALM