Kajian Penggunaan Carbon Black N990 sebagai Bahan Pengisi Kompon Karet Alam: Sifat Dinamik, Kestabilan Termal, dan Ketahanan Panas

Authors

  • Adi Cifriadi Rubber Research Center, Palembang, Indonesia
  • Purwantiningsih Sugita Department of Chemistry, Faculty of Mathematics and Natural Sciences, Institut Pertanian Bogor, Indonesia
  • Tetty Kemala Department of Chemistry, Faculty of Mathematics and Natural Sciences, Institut Pertanian Bogor, Indonesia
  • Siti Nikmatin Department of Physics, Faculty of Mathematics and Natural Sciences, Institut Pertanian Bogor, Indonesia

DOI:

https://doi.org/10.25077/jrk.v14i1.560

Keywords:

rubber, Carbon Black N990, dynamic, thermal stability, heat resistance

Abstract

The manufacture of vibration damping material from natural rubber (NR) required an increase in dynamic properties, thermal stability, and resistance to heat. Using the Carbon Black N990 as a filler in NR vulcanizates can potentially increase on these properties. This research aims to study the effect of using Carbon Black N990 on dynamic properties, thermal stability, and aging resistance to heat in NR vulcanizates. The dynamic properties of NR vulcanizates were determined by Rubber Process Analyzer (RPA), while the thermal stability properties were studied by TGA, and heat resistance was determined by the thermal aging test. The RPA test results showed that adding 50 phr Carbon Black N990 in the NR compound could increase the value of the complex shear modulus to 65%. Furthermore, the results of the TGA test showed that the thermal stability properties of unfilled NR vulcanizates were better than that of NR vulcanizates containing Carbon Black N990. Unfilled NR vulcanizates were heat stable up to 353oC, while NR vulcanizates containing 15, 30, and 50 parts per hundred rubber (phr) Carbon Black N990, respectively, were heat stable up to 348.1oC, 348oC, and 349oC. Based on the requirements of ISO 4632-1, it showed that the NR compound containing Carbon Black N990 has good heat resistance properties. The NR compound formula contains 30 phr Carbon Black N990 showing good dynamic properties and heat resistance in accordance with EN 15129 requirements so that it has the potential to be used as a vibration damping material for earthquake-resistant structures.

References

Maciejewska, M. & Sowińska, A., Influence of fillers and ionic liquids on the crosslinking and performance of natural rubber biocomposites. Polymers (Basel)., 13(10): (2021).

Marhoon, I. I., Mechanical And Physical Properties Of Polyurethane Composites Reinforced With Carbon Black N990 Particles. Int. J. Jof Sci. Technol. Res., 6(08): 225–228 (2017).

Hujare, P. P. & Sahasrabudhe, A. D., Experimental Investigation of Damping Performance of Viscoelastic Material Using Constrained Layer Damping Treatment. Procedia Mater. Sci., 5: 726–733 (2014).

Halladay, B. J. R. & Jaglowski, K. T., Sources of hysteresis in rubber compounds Technical. 13–17 (2017).

Hentschke, R., The P ayne effect revisited. 11(4): 278–292 (2017).

Le Cam, J. B., Energy storage due to strain-induced crystallization in natural rubber: The physical origin of the mechanical hysteresis. Polymer (Guildf)., 127: 166–173 (2017).

Shi, G., Wang, W., Lu, H., Wang, G., Yang, F. & Rui, X., Study of crosslink structure and dynamic mechanical properties of magnetorheological elastomer: Effect of vulcanization system. J. Intell. Mater. Syst. Struct., 30(8): 1189–1199 (2019).

Su, C., Zhao, C., Xu, L. & Zhang, C., Effects of chemical structure of phenolic resin on damping properties of acrylate rubber-based blends. J. Macromol. Sci. Part B Phys., 54(2): 177–189 (2015).

Lei, T., Zhang, Y. W., Kuang, D. L. & Yang, Y. R., Preparation and properties of rubber blends for high-damping-isolation bearings. Polymers (Basel)., 11(8): (2019).

Abedi Koupai, S., Bakhshi, A. & Valadoust Tabrizi, V., Experimental investigation on effects of elastomer components on dynamic and mechanical properties in seismic isolator compounds. Constr. Build. Mater., 135: 267–278 (2017).

Mohamad, N., Yaakub, J., Ab Maulod, H. E., Jeefferie, A. R., Yuhazri, M. Y., Lau, K. T., Ahsan, Q., et al., Vibrational damping behaviors of graphene nanoplatelets reinforced NR/EPDM nanocomposites. J. Mech. Eng. Sci., 11(4): 3274–3287 (2017).

Wang, Y., Liao, L., Lin, H., Zhang, F., Zhong, J., Xu, K. & Peng, Z., Damping Properties of Natural rubber/ Epoxidized Natural Rubber composites with different fillers. (January): (2018). doi:10.2991/ifeesm-17.2018.145

Wang, J., Zhao, X., Wang, W., Geng, X., Zhang, L., Guo, B., Nishi, T., et al., Significantly Improving Strength and Damping Performance of Nitrile Rubber via Incorporating Sliding Graft Copolymer. Ind. Eng. Chem. Res., 57(49): 16692–16700 (2018).

Li, J. C., Zhang, H. S., Zhao, X. Y., Jiang, J. G., Wu, Y. X., Lu, Y. L., Zhang, L. Q., et al., Development of high damping natural rubber/butyl rubber composites compatibilized by isobutylene-isoprene block copolymer for isolation bearing. Express Polym. Lett., 13(8): 686–696 (2019).

Murniati, R., Rahmayanti, H. D., Utami, F. D., Cifriadi, A., Iskandar, F. & Abdullah, M., Effects of magnetically modified natural zeolite addition on the crosslink density, mechanical, morphological, and damping properties of SIR 20 natural rubber reinforced with nanosilica compounds. J. Polym. Res., 27(2): (2020).

Ma, R., Zhang, X., Liu, C. & Wu, W., Hindered phenol-mediated damping of polyacrylate rubber: Effect of hydrogen bonding strength on the damping properties. J. Polym. Eng., 39(7): 642–652 (2019).

Andriani, W., Cifriadi, A. & Puspitasari, S., Pengaruh Jenis Arang Hitam Terhadap Sifat Mekanik Komposit Karet Alam Pada Vulkanisat Elastomer Bantalan Jembatan. J. Penelit. Karet, (October): 65–74 (2019). doi:10.22302/ppk.jpk.v37i1.606

Gao, T., Xie, R., Zhang, L., Gui, H. & Huang, M., Use of Rubber Process Analyzer for Characterizing the Molecular Weight Parameters of Natural Rubber. Int. J. Polym. Sci., 2015: (2015).

Yunus, N. A., Mazlan, S. A., Ubaidillah., Abdul Aziz, S. A., Shilan, S. T. & Abdul Wahab, N. A., Thermal stability and rheological properties of epoxidized natural rubber-based magnetorheological elastomer. Int. J. Mol. Sci., 20(3): 1–19 (2019).

Hiranobe, C. T., Ribeiro, G. D., Torres, G. B., Dos Reis, E. A. P., Cabrera, F. C., Job, A. E., Paim, L. L., et al., Cross-linked density determination of natural rubber compounds by different analytical techniques. Mater. Res., 24(S1): 1–9 (2021).

Larpkasemsuk, A., Raksaksri, L., Chuayjuljit, S., Chaiwutthinan, P. & Boonmahitthisud, A., Effects of sulfur vulcanization system on cure characteristics, physical properties and thermal aging of epoxidized natural rubber. J. Met. Mater. Miner., 29(1): 49–57 (2019).

Alshabatat, N. & Abouel-Kasem, A., The Effects of Sulfur Content on the Mechanical Properties of Nitrile Butadiene Rubber with Different Aging Conditions. Jordan J. Mech. Ind. Eng., 15(4): 387–393 (2021).

Kim, D. Y., Park, J. W., Lee, D. Y. & Seo, K. H., Correlation between the crosslink characteristics and mechanical properties of natural rubber compound via accelerators and reinforcement. Polymers (Basel)., 12(9): 1–14 (2020).

Han, S., Gu, B., Kim, S., Kim, S., Mun, D., Morita, K., Kim, D., et al., Effect of sulfur variation on the vulcanizate structure of silica-filled styrene-butadiene rubber compounds with a sulfide–silane coupling agent. Polymers (Basel)., 12(12): 1–14 (2020).

Hayeemasae, N. & Masa, A., Relationship between stress relaxation behavior and thermal stability of natural rubber vulcanizates. Polimeros, 30(2): (2020).

Downloads

Published

2023-03-24

How to Cite

Adi Cifriadi, Sugita, P. ., Kemala, T. ., & Nikmatin, S. (2023). Kajian Penggunaan Carbon Black N990 sebagai Bahan Pengisi Kompon Karet Alam: Sifat Dinamik, Kestabilan Termal, dan Ketahanan Panas. Jurnal Riset Kimia, 14(1), 25–34. https://doi.org/10.25077/jrk.v14i1.560

Issue

Vol. 14 No. 1 (2023): March

Section

Articles

Citation Check

License

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Please find the rights and licenses in Jurnal Riset Kimia (J. Ris. Kim). By submitting the article/manuscript of the article, the author(s) agree with this policy. No specific document sign-off is required.

1. License

The use the article will be governed by the Creative Commons Attribution license as currently displayed on Creative Commons Attribution 4.0 International License. 

2. Author(s)' Warranties

The author warrants that the article is original, written by stated author(s), has not been published before, contains no unlawful statements, does not infringe the rights of others, is subject to copyright that is vested exclusively in the author and free of any third party rights, and that any necessary written permissions to quote from other sources have been obtained by the author(s).

3. User Rights

Under the Creative Commons license, the journal permits users to copy, distribute, and display the material for any purpose. Users will also need to attribute authors and J. Ris. Kim on distributing works in the journal and other media of publications.

4. Rights of Authors

Authors retain all their rights to the published works, such as (but not limited to) the following rights;

  • Copyright and other proprietary rights relating to the article, such as patent rights,
  • The right to use the substance of the article in own future works, including lectures and books,
  • The right to reproduce the article for own purposes,
  • The right to self-archive the article,
  • The right to enter into separate, additional contractual arrangements for the non-exclusive distribution of the article's published version (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.

5. Co-Authorship

If the article was jointly prepared by more than one author, any authors submitting the manuscript warrants that he/she has been authorized by all co-authors to be agreed on this copyright and license notice (agreement) on their behalf, and agrees to inform his/her co-authors of the terms of this policy. J. Ris. Kim will not be held liable for anything that may arise due to the author(s) internal dispute. J. Ris. Kim will only communicate with the corresponding author.