PEMBUATAN LAPISAN TIPIS DAN SERBUK TIMBAL TITANAT DENGAN METODA SOL GEL

Authors

  • Rahmayeni -
  • Emriadi -
  • Eli Susanti
  • Delfi Silvia

DOI:

https://doi.org/10.25077/jrk.v1i1.62

Abstract

 

ABSTRACT

 

Thin layer and powder of lead titanate had been prepared using lead acetate and tetraethylorthotitanate as precursor by sol gel process. The thin layer of composite was obtain through layering the composite on glass substrate. Both thin layer and powder were calcined between 100-700°C and were characterized by Scanning Electron Microscopy (SEM), X-ray diffraction (XRD), UV and Fourier Transform Infra Red (FTIR). The diffraction pattern show that the structure of composite on glass substrate is amorf at 500°C and could not identified at 700°C while the powder is crystalline at 500 and 700°C. FTIR spectra shown the Ti-O peak at 1407 cm-1, the Pb-O and Pb-O-Ti peaks at 718 and 600 cm-1, respectively. 

References

Camargo, E. R., Kakihana, M., 2001, Peroxide - Based Route Free from Halides for the Synthesis of Lead Titanat Powder, J.Chem. Mater., 13: 1181-1184.

Li, Z., Wu, A., and Vilarinho, P.M., 2004, Perovskite Phase Stabilization Of Pb(Zn1/3Ta2/3)O3 Ceramics Induced by PbTiO3 Seed, J. Chem. Mater., 16: 718-719.

Bosak, A.A., Samoilenkov, S.V., Gorbenko, O.Y., Graboy, I.E., Botev, A.N., Kaul, A.R., 2001, Self-tuning MOCVD Approach to the Growth of Very Smooth La1-xPbxMnO3 and PbTiO3 Epitaxial Thin Films, J. Chem. Mater., 13: 981-986.

Tang, X.G., Ding, A.L., Ye, Y., and Chan, H.L.W., 2002, Preparation and Characterization of Lead Zirconate Thin Films by Chemical Solution Deposition, J. Chem. Mater., 14: 2129.

Briggle, J., Petuskey, W.T., Shemkunas, M., 2000, Perovskite Electroceramics. Departement of Chemistry, Arizona State University, Materials Research Science and Engineering Centre (MRSEC). Winter Workshop, January.

Schwartz, R.W., 1997, Chemical Solution Deposition of Perovskite Thin Films, J. Chem.Mater., 9: 2325-2340.

Brinker, C. J., Hund, A.J., 1990, Fundamental of Sol-Gel Dip-Coating. Sol-Gel Science and Technology, 158-159.

Seveno, R., Limousine, P., Averty, D., Chartier, J-L., Le Bihan, R., Gundel, H.W., 2000, Preparation of Multi-Coating PZT Thick Films by Sol-Gel Method onto Stainless Steel Substrates, J. European Ceramic Society., 20: 2025-2028.

Jamarun, N., 2000, Proses Sol-Gel. Jurusan Kimia Fakultas Matematika dan Ilmu Pengetahuan Alam Universitas Andalas Padang, hal. 1-23.

Fang, J., Wang, J., Ming, L., Ng, S.C., 2002, Comparative Study on Phase Development of Lead Titanate Powders, J. Mat. Letters., 52: 304-312.

Fang, J., Wang, J., Ming, L., Ng, S.C., 2002, J. Mat. Letters, 52, 304-312.

Smith, A.L., 1979, Applied Infrared Spectroscopy, A.Wiley-Interscience Publication, Jhon Wiley & Sons, Vol. 54, 184-185.

Sibilia, J.P., 1996, A Guide to Materials Characterization and Chemical AnalysisI. Wiley-VCH USA, Inc. 2nd Edition, 17-21, 143-147, 167-171.

Downloads

Published

2015-02-12

How to Cite

-, R., -, E., Susanti, E., & Silvia, D. (2015). PEMBUATAN LAPISAN TIPIS DAN SERBUK TIMBAL TITANAT DENGAN METODA SOL GEL. Jurnal Riset Kimia, 1(1), 31. https://doi.org/10.25077/jrk.v1i1.62

Issue

Vol. 1 No. 1 (2007): September

Section

Articles

Citation Check

License

Please find the rights and licenses in Jurnal Riset Kimia (J. Ris. Kim). By submitting the article/manuscript of the article, the author(s) agree with this policy. No specific document sign-off is required.

1. License

The use the article will be governed by the Creative Commons Attribution license as currently displayed on Creative Commons Attribution 4.0 International License. 

2. Author(s)' Warranties

The author warrants that the article is original, written by stated author(s), has not been published before, contains no unlawful statements, does not infringe the rights of others, is subject to copyright that is vested exclusively in the author and free of any third party rights, and that any necessary written permissions to quote from other sources have been obtained by the author(s).

3. User Rights

Under the Creative Commons license, the journal permits users to copy, distribute, and display the material for any purpose. Users will also need to attribute authors and J. Ris. Kim on distributing works in the journal and other media of publications.

4. Rights of Authors

Authors retain all their rights to the published works, such as (but not limited to) the following rights;

  • Copyright and other proprietary rights relating to the article, such as patent rights,
  • The right to use the substance of the article in own future works, including lectures and books,
  • The right to reproduce the article for own purposes,
  • The right to self-archive the article,
  • The right to enter into separate, additional contractual arrangements for the non-exclusive distribution of the article's published version (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.

5. Co-Authorship

If the article was jointly prepared by more than one author, any authors submitting the manuscript warrants that he/she has been authorized by all co-authors to be agreed on this copyright and license notice (agreement) on their behalf, and agrees to inform his/her co-authors of the terms of this policy. J. Ris. Kim will not be held liable for anything that may arise due to the author(s) internal dispute. J. Ris. Kim will only communicate with the corresponding author.